Calibre Electric Inc

Electricians
Burlington ON L7P 1A1
Write a Review
Write a Review


HomeStars  >  Electricians in Embro  >  Calibre Electric Inc  >  Hot tun electrical install and 60 to 100 amp upgrade panel
a.koschate in Burlington
a.koschate in Burlington
2 reviews Burlington, ON
1/10

Hot tun electrical install and 60 to 100 amp upgrade panel

I thought I’d get a professional job done, especially for the price I paid - but I was wrong. Babysitting was needed to get the job done. They forgot to do work as agreed upon until I reminded them: install a cable, get rid of an A/C copper pipe, install a surge protection device. They were having a special - normally the sell the device for $349 plus $185 service call, but because I was having them install a new panel they offered it at a bargain price of $ 249+ hst. Unfortunately, they write their estimated up in a manner in which you have no idea what equipment you’re getting. This device was about the cheapest of its kind - less than $50 at Home Depot. It can be installed in a couple minutes. There are better units that cost more and take more time to install - something which I thought I would be getting. Poor workmanship is another issue. When the panel was installed, they elected to destroy my enclosure cabinet and cut the panel into the drywall below. They said it was too long. After the job, I noticed that if they had taken an additional 15 minutes of time, they could have cleared out two useless junction box an obsolete heater panel to make sufficient room for the new panel. Instead - it was a job of slap it in and get it done as quick as possible. Outside, they left a ground wire draped across the new spa panel. Was it needed I asked? No the electrician says - he cut them off his house as they are problematic. So why leave it draped over a new electrical panel? He took a side cutters and removed it in less than 30 seconds. Two electricians came, but only man worked, while the other spent most of his time making calls - no for my job through - for other jobs (at my cost). The spa install was an easy job - involved routing 20 feet of interior cable along a ceiling, into an outdoor spa box, laying another 20 feet of outdoor cable and connecting into the spa. I dug and backfilled the 18-inch deep trench for the cable and provided them with a hole in the block house wall. Essentially, one man worked for less than 4 hours to get the job done and the overall bill to me was $2400, which I was told a couple times that it would take a full day. It took me 5 hours to do the trench (and cut sidewalk concrete) - at their rates, I’d hate to know what that would have cost me in addition. Now, the $2400 bill included $145 for an ESA permit for the hot tub and a $90 ESA permit fee for the panel upgrade. I assume that’s legit, but I don’t know. After seeing what was installed, I found that I could by all the parts for under $800 at Home Depot. The Siemens main panel Calibre installed is a piece of junk. The switch labels are too hard to read of because of poor labelling and upside down geometry. On the other hand, the Eaton spa box was good. In the afternoon - they waited for hydro - I offered them cash to do some other work around the house. After waiting for several hours they followed up with Hydro - as it turned out Burlington Hydro had not been called back. An error made on the ESA inspector. They decided to leave since it would take more time for Hydro to show up and decided to leave the main panel on so the house would power up. They told me they would have to come back to label the new box. I’m away and come back to the house and find Hydro sitting. They can’t hook up the power. Apparently, it was wrong for the electrician to leave according to Hydro. Hydro won’t turn on power without confirmation that the main panel is “off”. I waited a week for Calibre to return to finish the job. I call Jeff and voice my concerns. Instead of coming over, he tells me to send some pictures. I email him the info. Another week goes by and he doesn’t call. I call and he says he busy. He says my expectations differed from theirs. They’ll get back to completing the job at my house when they get time. Well, it been over a month now and they have not come back. I went to Calibre because my Jacuzzi dealer recommended me to them. As a result, I did not bother to get estimates. I thought the price seemed steep, but then I thought I was going to get a professional, quality and with good support. I as wrong in all three counts. I told Jeff that I would be writing this and that I would also let my Jacuzzi dealer know. He didn’t care. I recalled seeing a Calibre business card indicating that they pay for referrals. I guess I won’t be getting anything. Funny thing is - I never even asked Jeff for anything but to review my concerns with me. Lesson learned - get quotes, find out what equipment is being installed, get labour time and rates. It is the only way to know what to expect.

Approximate cost of services:
$2,400.00
1 of 2 people found this review helpful.
Was this review helpful?